Is there anyway to show, as you can in vensim, the name of the simulation run you are seting up. At this stage when you load runs the name of that run is not visible. Is there a way of doing this?
Thanks
David
Show the Simulation Run
Moderator: Administrator
-
- Super Administrator
- Posts: 4589
- Joined: Wed Mar 05, 2003 3:10 am
Re: Show the Simulation Run
Add some text to the screen, and in it enter
The @RUNNAME@ will be replaced with the current run name.
You can also use
and the following to display the runs that are currently loaded.
Code: Select all
Runname = @RUNNAME@
You can also use
Code: Select all
@RUNNAMENOPATH@
Code: Select all
@RUN0@
@RUN1@
...
@RUNn@
Advice to posters seeking help (it really helps us to help you)
http://www.ventanasystems.co.uk/forum/v ... f=2&t=4391
Units are important!
http://www.bbc.co.uk/news/magazine-27509559
http://www.ventanasystems.co.uk/forum/v ... f=2&t=4391
Units are important!
http://www.bbc.co.uk/news/magazine-27509559
Re: Show the Simulation Run
Thanks
David
David