Reference modes in Vensim

malli · Post by **malli** » Wed Nov 15, 2006 5:04 pm

Hi,

I had a query on drawing reference modes in Vensim. Its a great utility and helps one get over the pains of doing it in word or powerpoint.

But, I am not able to show the 'Fear' and 'hope' lines in the same reference mode. Is there some way to do that in the current reference mode function in Vensim?

Thanks
Malli

bob@vensim.com · Post by **bob@vensim.com** » Thu Nov 16, 2006 10:45 am

Hi Mali,

Fear and Hope are two different reference modes. Call one Fear, and the other hope. You can only draw them one at a tme but they will show up together on graphs.

malli · Post by **malli** » Thu Nov 16, 2006 11:55 am

Hi Bob,

Thanks! Will check it out

Malli