Ventana software support forum

Hi,

I had a query on drawing reference modes in Vensim. Its a great utility and helps one get over the pains of doing it in word or powerpoint.

But, I am not able to show the 'Fear' and 'hope' lines in the same reference mode. Is there some way to do that in the current reference mode function in Vensim?

Thanks
Malli

Hi Mali,

Fear and Hope are two different reference modes. Call one Fear, and the other hope. You can only draw them one at a tme but they will show up together on graphs.

Hi Bob,

Thanks! Will check it out

Malli