Page 1 of 1
How could I control a decimal point.....
Posted: Mon Jul 16, 2007 9:04 am
by gk720421
How sould I do when the final number's decimal point
Such as 5 ,5.5 , 5.58 or 5.586
Posted: Mon Jul 16, 2007 10:36 am
by Administrator
Go to Tools->Options then select "Settings". There is a checkbox near the bottom for "Use European number format for displayed output".
Hope this helps.
Tony.
Posted: Tue Jul 17, 2007 2:38 am
by gk720421
thanks!
Posted: Tue Jul 17, 2007 8:39 am
by gk720421
How could I select in vensim to do "523"------>"523.00" or "452.293"---->"452.29"
thanks
Posted: Tue Jul 17, 2007 8:50 am
by gk720421
I find that
Go to Tools->Options then select "Settings". There is a checkbox near the bottom for "Use European number format for displayed output".
It show that if answer should be "5.281"---turn -->"5,281" I assume answer is 5281 ,not 5.28
how can I improve?
thanks.
Posted: Tue Jul 17, 2007 9:02 am
by Administrator
>> It show that if answer should be "5.281"---turn -->"5,281" I
>> assume answer is 5281 ,not 5.28
If you are using European number formatting, 5.2 will show as 5,2. The number is still the same (5.2 = 5,2).
Tony.
Posted: Tue Jul 17, 2007 9:04 am
by Administrator
Originally posted by gk720421
I find that
Go to Tools->Options then select "Settings". There is a checkbox near the bottom for "Use European number format for displayed output".
It show that if answer should be "5.281"---turn -->"5,281" I assume answer is 5281 ,not 5.28
how can I improve?
thanks.
Are you using the table tool? If yes, right click on the table tool and you can see some options. Experiment a little with "number format" and see if it does what you need.
All the best,
Tony.
Posted: Wed Jul 18, 2007 12:26 pm
by gk720421
thank you very much!