Ventana software support forum

My Vensim is PLE,

whenever I make a model and give arrows for them, they keep missed after I close and reopen.

(but the arrow DO exists, but is not viewed)

These are the shoots for this problem:



-before closing-



-after closing and reopen-



-to show connection exists-



thanks for helping my problem
http://img357.imageshack.us/img357/3734/shoots1dz9.jpgScreenshoot1

[Edited on 1-7-2009 by divinelight]

sorry for double post, but I cannot edit anymore after 4 times editting.
(because I'm not familiar with the BBCode here)

-before closing-
http://img357.imageshack.us/img357/3734/shoots1dz9.jpg

-after close and reopen-
http://img525.imageshack.us/img525/6358/shoots2ej5.jpg

-show connection exists-
http://img187.imageshack.us/img187/8014/shoots3ae1.jpg

that's the problem, basically the arrow is not shown

Can you try clicking Model->Options, then click "Sketch". Make sure "Show initial causes on model diagrams" is ticked and see if this solves the problem?

Tony.

Make sure you are using version 5.8c. If you could post the model that would I can take a look to see why things are not visible.