Ventana software support forum

Hi!

I am working with Vensim Standard 5.6d.
I have a model with 10 views. i.e. View 1: Demand Model; View 2: Capacity Model; View 3: Productivity Model; and so on...
I am looking for a way to integrate those "sub-models" in a only model view, just to make a presentation.
Of course that If I copy and past I would do it but I would like to know if there is some tool for that. I could not find so far.

Thank you

Cláudio

I don't know of a way.

It might be better though to create an overview diagram using comments rather than copy all ten views into one. You can then link each "comment" with the view it represents. It would lead to a much less cluttered diagram, but still retain the ability to visit each module in detail should you need to.

Hope this helps.

Tony.

Thank you Tony

Best regards

Claudio