Page 1 of 1

Test model by model

Posted: Fri Nov 26, 2010 2:57 pm
by almoon
I have several model and when I do the simulation its give me strange results so can I test model by model ( all the models are connected to each other ) to can figure out where is the mistake?

Posted: Fri Nov 26, 2010 5:17 pm
by tomfid
How are these models linked? Does something prevent you from executing them one at a time and looking at the results?

Posted: Fri Nov 26, 2010 7:18 pm
by almoon
if the same variables are used in more than one model, how can I execute them one at a time?

Posted: Sat Nov 27, 2010 12:34 am
by tomfid
Vensim doesn't support federation of models, so I'm not sure what you mean. What happens when you use Model>Simulate to run your model(s)?