Ventana software support forum

Hi

Is there any way to get a slider to operate between 0 and 1? I tend to use these values for percentages e.g. 0.45 rather than 45%.

Thanks

David

Set the min to 0, max to 1, and the tick frequency to .1 (or whatever you need it at).

Is this not working for you?

Thanks - yep it does work. Just didn't think about the 'tick' range. I learn something every time I create a new interface. However it leads to another issue. I'm using subscripts - in this case 'male' and 'female'. Using the edit box I can get it to 'display all combinations' and thereby display the male or female subscript elements. The slider doesn't allow this. I can edit it directly and change the range 'gender' to either of the subscript elements and it seems to work. However, when I do that the reset button I've set up does not work.

Thanks again or your prompt and helpful replies.

David

Can you email me the screen with the problem and I'll take a look?