Ventana software support forum

I've attached a simple model that replicates an issue I'm having in a larger model. It's got three stocks, initialized to 315400, 5810, and 600 units. There's a Total variable that does what it implies.

However, it says the total is 321800, while my calculator and my brain say it should be 321810.

Is that the single-precision DLL at work, or is there something else going on? I'm running DSS 6.4E (x32).

As far as policy goes, this is a non-issue. I found it as part of a mass balance check to make it easy to see that I was initializing stocks to get the desired total. I knew the total I wanted (321800), and so I thought the initialization was working until I added the numbers manually.

Thanks,

Bill

If you right click on the table tool and select "Scientific" instead of "Pretty" for the number format, does the correct value show up?

Thanks--much better.

I learned something!

Bill