Ventana software support forum

Hi,
I would like to understand if there is any way to run PENSIM models with a Visual Basic program. This to facilitate running one set of models (7 models)seamlessly as presently I have to open one at a time to get the results at the end.
Regards,
Louis

Do you mean running models in parallel? This is difficult.

There is an example on how to use Visual basic with the Vensim DLL (search in c:\users\public\vensim). But this will only allow one model to run at a time.

It sounds like you're running a chain of models, where the output from one is the input to the next. This is easy with a command script (requires Vensim DSS).