blank sliders in synthsim

Steve Taff · Post by **Steve Taff** » Tue Sep 09, 2008 3:54 pm

Using 5.8. This happens on only one machine; another works fine. Same model on both.

Open model to page with an Input Output slider. Run Synthesim by clicking little button at top. Slider goes blank and can't be used. Refresh screen by zooming to different size, slider is visible and operational again. Close Synthesim and slider is fine. Run Synthesim again and slider is blank. Rezoom......

Any ideas on this one? Not a big issue, just an annoyance.

bob@vensim.com · Post by **bob@vensim.com** » Wed Sep 10, 2008 10:23 am

It sounds like a timing issue, but not one I have seen. If you want to email me the model I will take a look to see if I can reproduce it.

Steve Taff · Post by **Steve Taff** » Fri Oct 10, 2008 3:00 pm

The new version seems to have fixed this problem. Thanks!

Steve Taff · Post by **Steve Taff** » Wed Oct 15, 2008 10:28 pm

Actually, the new version fixed the problem on my laptop, but now I've got something similar (screen refresh issue) on my desktop--which didn't have any problem with the previous version. Ain't computers wonderful!?!

FWIW, my desktop card is Radeon X1300/X1550 Series, with the 9/298/2007 drivers from ATI.

bob@vensim.com · Post by **bob@vensim.com** » Thu Oct 16, 2008 10:09 am

Try 5.8b which is now up - see if that changes anything.