Vensim PLE and 64 bit Windows

mmurrauy · Post by **mmurrauy** » Mon Jun 03, 2013 2:58 pm

Hi folks,
I am running Windows 7 (64 bit) and I am unable to run any Vensim models or manipulate them. Everything I open is "locked sketch" and the error reads that I can only use the system in sketch view..

Does anyone have any ideas on if and how I can evaluate this system?
Cheers,
Mike

Post by **Administrator** » Mon Jun 03, 2013 3:11 pm

Can you post one of the offending models?

Post by **tomfid** » Mon Jun 03, 2013 4:19 pm

I rather doubt that the operating system has anything to do with it, because loads of people are running Vensim in 64bit environments.

Post by **tomfid** » Mon Jun 03, 2013 4:43 pm

Do the models you're trying to use originate in PLE, or some higher version? Can you open & run them with the Model Reader?

Ventana software support forum

Vensim PLE and 64 bit Windows

Vensim PLE and 64 bit Windows

Re: Vensim PLE and 64 bit Windows

Re: Vensim PLE and 64 bit Windows

Re: Vensim PLE and 64 bit Windows