Save time step
Posted: Fri Feb 22, 2019 9:06 am
Hi, I might be doing this wrong but cannot seem to figure out if it is possible, so I am asking here.
I have long simulations, and I do not need the simulation results for each time step, so I would like to cut down on output file size by reducing the frequency that results are saved, similar to the SAVEPER in Vensim. I have tried altering the settings in Run Control but "Save Time Step", "Initial Save Time", and "Final Save Time" do not seem to actually affect anything.
I have long simulations, and I do not need the simulation results for each time step, so I would like to cut down on output file size by reducing the frequency that results are saved, similar to the SAVEPER in Vensim. I have tried altering the settings in Run Control but "Save Time Step", "Initial Save Time", and "Final Save Time" do not seem to actually affect anything.